Car Brake Tools: Periodic checking Brake Tool

One of the most vital tool found in a vehicle is the brakes. I do not know any of the vehicles, because among the many causes of injury caused by motor vehicle, one of which are due to the brakes. Therefore must be observed if you want to travel with a good drive in the city or out of the city, should always pay attention to brakes that are on your vehicle, especially in the car.

According to Gunawan Indrajati, Service Manager at Toyota Tunas dibilangan Mampang located in South Jakarta, "there are a variety of things to do in a car braking system is disrupted, even at the extreme conditions that is, not the proper functioning of a number of indicators on the braking system can cause the brakes on the car relieved. "


If the braking system on the car does not work well, there are several possible causes for the occurrence of the matter, namely:
A. The brakes are worn-out canvas
Two. Available on a sliding caliper, usually dirty and rusty and do not work as befits the caliper.
Three. Not functioning due to caliper brake oil leak that there are rubber seals wear.

Because the system and how it works is quite complicated, it is recommended to bring the car to the nearest car workshops, or in a workshop that has been shown to improve the braking system. But if you only have to fix their own home, or while they are in travel, probably a good idea if the steps below:


A. Remove the tire from the axle of wheel (if the braking system with brake disc braking device then you might see,
if using the lid on Tromol Tromol or drum brake device must be opened first so that braking can be seen).

Two. After that check the brake canvas, but you should know before, which is still good brakes canvas and is not eligible to apply again. (Do brake replacement on canvas that has been damaged).

Three. If it appears there are no abnormalities seen on canvas brake, disc brake for that use, it does not tend caliper
function properly as a result of the sliding bolts rust even dirty, open the sliding bolt with wrench, then clean the dengankain clean and when there is rust you can clean them with a fairly coarse sandpaper and give it fat enough.


4. While in the braking system that uses Tromol,

likely the problem is in the wheel cylinder brake canvas as a starting point.
Five. Brake oil leak is usually so relieved to make the brakes, check the rubber seal found on the caliper, if there is oil wetting liquid rubber seal on the seal replacement done immediately.

To avoid the occurrence of the things that you do not want on your vehicle braking system, a good idea to do periodic checks on a routine basis at designated workshops. "It is recommended that periodic checks on the braking system performed on each vehicle reaches 10,000 miles, and a further 10,000 kilometers of each multiplier." Says Gunawan Indrajati close chat.



  • READ MORE.......


  • Ahmad Garuda


    for more details and updates about automotive-technology-guide please visit.........
    www.automotive-technology-guide.com

    ---or---

  • www.automotive-technology-guide.com


  • Share on :

    0 comments:

    Post a Comment