Beware of Your Car Theft

Lately a lot of car thefts. The thieves did not seem out of his mind to launch the action.

One of them by prying the car to be able to take anything valuable in the car. We created the car owners alarmed by it.

Techniques that will open a stolen car can vary. Usually, the most commonly used are:

1. By slipping a wire or a ruler to the gap between the glass and the outer wall of the car door.

Then the tool was used to suppress or prying-handlebars handlebars inside the door and release the key.

Once the doors unlock handlebars tercongkel or depressed, the key will open soon.

2. Through the vehicle rear lights, which only covered the interior panels.

The way it is often used by thieves handed slim. Once the lights back open, he would slip his hand through the panel. Then lock the door can be easily opened from the inside.

There are some tricks that we can use to outsmart the thieves are. We can not be defeated by clever thieves dong. Here's how:

Theft by wire to the door slid techniques

We will make a ruler so hard to wire or weaving in the gap between wall and glass with a bulkhead divider. For that we need the help of some tools and assistance welder.

Here's how:

1. Lift the rubber seals on the outside (outer wheater strip). But remember not to bend, because it would be difficult to straighten it again. Measure the width of the gap that will be given a bulkhead from the inside. Measure also the distance between the lip plate on the wall with glass doors. If it has been known to reduce the size of 2-3 mm, so that the tip does not scratch the surface of the glass plate. This last result will be used for tracing.

2. Make a cardboard pattern on paper in accordance with the results of slit width and the distance to the glass wall with a door width of the pattern of greater value to about 3-5 mm. This section will be used as part of the plate that attaches to the lip plate door. Give shading to distinguish.

3. Apply bulkhead line on the candidate, then cut the plate in accordance with the pattern. Remember, do not let any protruding parts. If there is a prominent, puree with sandpaper or grinding.

4. Plates that have stayed the same as the pattern on the lip plate affixed to the door. By way of bending the plate according to the shaded part. The result is L-shaped when viewed from the side. Smear the bulkhead with paint so as not to be attacked termites or rust.

5. To paste it, weld it on the lip plate bulkhead under the door. Caution, not to interfere with the welding point of motion up and down the glass window. Close points welding with paint so as not easily corroded. Then replace the rubber cover selahnya.

Theft by prying technique taillights

So that thieves can no longer pick the space behind the rear lights car lights must be isolated.

The trick as follows:

1. Lights off, and then measure the length and width and then create patterns on paper. Transfer the pattern onto the metal plate.

Cut the plate according to the pattern, not to exceed the line tracing plate was difficult to install.

2. Rub the plate with sandpaper, give water little by little so that the surface smooth and flat plate dry freshly painted first, so as not to rust.

3. Then weld the plate on the car body, carefully so as not to damage the other car components. When welding the lid part affected by the fires hot with a wet cloth.

4. Cat back plate and the point of welding to prevent flaking of the paint due to welding and protected from corrosion. The latter replace the lamp.

READ MORE.......

for more details and updates about automotive-technology-guide please visit.........

www.automotive-technology-guide.com

---or---

www.automotive-technology-guide.com